11.1.1 DICOM Service (PACS Server functionality)
The DICOM Viewer can take on the role of a PACS server. The data in the Local Storage will be
available for clients. To do this, enable and set up the DICOM Service and add clients to the PACS
Servers list (section 11.2). To set up the DICOM Service:
- Select the Services... item from the Network menu. The dialog box shown in Fig. 11.1
will pop up.
- Check the Enable DICOM Listener box.
- In the AETitle field, enter a user-defined title for the computer that the is installed on to
identify it on the server.
- In the Port field, specify any free port of the computer the DICOM Viewer is installed on. If
you are not sure which value to specify, use the default value. This information can be obtained
from your system administrator.
- Click Apply. If the port is busy, the message Dicom Listener cannot be run. Error
message: The address is protected will pop up. In this case, select another port and repeat
the previous action.
11.1.2 HIS/HTTP Service
This service is used to manage the DICOM Viewer using the http protocol.
To set up the HIS/HTTP Service:
- Check the Enable HIS/HTTP Service box.
- In the Port field under the Enable HIS/HTTP Service checkbox, specify any free
port of the computer the DICOM Viewer is installed on. If you are not sure which value
to specify, use the default value. This information can be obtained from your system
administrator.
11.1.3 Web Access
____________________________________________________________________________________________
Functionality is available in the Pro edition
____________________________________________________________________________________________
To set up the Web access:
- Check the Enable web Access box.
- In the Port field under the Enable web Access checkbox, specify any free port of the
computer the DICOM Viewer is installed on. If you are not sure which value to specify,
use the default value. For access from other computers, add the web access port to your
firewall exceptions. If necessary, contact your system administrator.
- In the User name field, enter the user name.
- In the Password field, enter the user password.
- In the Session timeout (sec.) field, enter a timeout after which the session is terminated
if the connection is lost. When the connection is restored, you need to enter your username
and password again.
At the bottom of the dialog, there is a link that must be entered into the browser for web
access to the DICOM Viewer http://youraddress:<port>, where instead of youraddress you
need to type in the ip address or the computer name on which the DICOM Viewer is
installed.